Step 1 :
Open the driver side doors and place the baby pad and the pry tool behind the front seat.

Step 2:
Place the power harness and the system on the front seat

Step 3:
Use the pry tool and lift up the molding in the web of the doors that finishes the carpet to the metal .

Step 4:
Lay your control harness under the carpet, "DO NOT" cover the holes that the molding clips go into.{If 4 door} Use a fish tape and push it the from front to back seat. Tape the wiring harness to the end of the fish tape and pull it gently back to the front with your friend guiding the harness. "(Be sure to keep the harness from sliding on the sharp metal as it goes in the direction it is being pulled.)"

"Back Seat" Next align the baby pad in the car seat and plug it into the control harness.
Tuck the cables to ensure a clean look. The back seat is finished.

"Front Seat" Pull the harness toward the front of the automobile with an extra two feet hanging out after it has reached the front of the driver side kick panel. Tuck the harness behind the kick panel and put the molding back on.

Step 5:
Plug the wiring harness into the system.

Step 6:
Plug the power Harness into the system then plug it in your OBD2 connector.

NOW TEST YOUR SYSTEM